Audio Technica Freeway 200 VHF Handheld Wireless Microphone SystemThe Audio-Technica’s Freeway 200 Series Wireless Systems are designed to provide reliable performance, easy setup and clear, natural sound quality.
Each 200 Series professional VHF wireless system includes a receiver and either a body-pack transmitter or a handheld microphone/transmitter on a specific crystal-controlled frequency. A novel dipole antenna system on the receiver improves operation by providing a ground element in addition to the usual signal element.
Audio-Technica 200 Series Features
- Easy operation and clear, natural sound quality
- Reliable performance and durable construction
- Advanced dipole antenna system for extended operating range
- Power, RF, and AF Peak indicators
- Volume control, 1/4-inch output jack and space-saving power supply
- Rugged unidirectional dynamic element on handheld microphone/transmitter
- Variable microphone trim control and easily accessible On/Standby/Off switch on transmitters
- Professional locking connector on UniPak body-pack transmitter
- Available in multiple system configurations
Multiple wireless units? Leading the industry again, AMS lets you choose your wireless frequency!
Channel Frequencies
- 169.505 MHz
- 170.245 MHz
- 171.905 MHz MHz
RECEIVER SPECIFICATIONS
- Receiving System Non-diversity, single-channel, dual antenna system
- Image Rejection 50 dB minimum
- Signal-to-noise Ratio 80 dB at 10 kHz deviation (IEC-weighted), maximum modulation 15 kHz
- Total Harmonic Distortion <=1% (10 kHz deviation at 1 kHz)
- Sensitivity 20 dBµV for 60 dB S/N (IEC-weighted)
- Audio Output 350 mV (1 kHz modulation, 10 kHz deviation, 100 k ohm load)
- Output Connector 1/4" TS ("mono") phone jack
- Power Supply 100-240V AC (50/60 Hz) to 12V DC 1A (center positive) switched mode external power supply
- Dimensions 7.48" (190.0 mm) W x
1.65" (42.0 mm) H x
5.12" (130.0 mm) D
--
- Net Weight 11.0 oz (311 g)
- Accessory Included Power supply
BODY-PACK TRANSMITTER SPECIFICATIONS
- RF Power Output 10 mW High position, 2 mW Low position, typical
- Spurious Emissions Under federal regulations
- Dynamic Range >=90 dB, A-weighted
- Input Connections High impedance, low impedance, bias
- Battery 9V (NEDA type 1604) alkaline, not included
- Current Consumption 30 mA typical
- Battery Life Approximately 15 hours in High position;
Approximately 20 hours in Low position
(depending on battery type and use pattern)
- Dimensions 2.56" (65.0 mm) W x
4.33" (110.0 mm) H x
1.00" (25.4 mm) D
- Net Weight 2.8 oz (78 g) (without battery)
HANDHELD TRANSMITTER SPECIFICATIONS
- RF Power Output 10 mW High position, 2 mW Low position, typical
- Spurious Emissions Under federal regulations
- Dynamic Range >=90 dB, A-weighted
- Microphone Element Dynamic unidirectional
- Battery 9V (NEDA type 1604) alkaline, not included
- Current Consumption 30 mA typical
- Battery Life Approximately 15 hours in High position;
Approximately 20 hours in Low position
(depending on battery type and use pattern)
- Dimensions 9.50" (241.3 mm) long,
2.10" (53.3 mm) maximum diameter
- Net Weight 12.7 oz (360 g) (without battery)
- Accessory Included AT8456a Quiet-Flex™ stand clamp
