Model Options:
- Overview
- Specs
- Manufacturer Info
- Also Purchased
- Video & Docs
Recommended Accessories
ex VAT
inc VAT
ex VAT
inc VAT
ex VAT
inc VAT
ex VAT
inc VAT
The Audio Technica M2 Wireless In Ear Monitor System lets you hear everything you want while at the same time, getting rid of the unwanted bulk of wedge monitors.
This stereo monitor system offers Personal Mix Control, which gives each musician volume and mix control of two independent signals on stage, via easy-to-use controls on the M2R stereo body-pack receiver. The wireless UHF M2T Stereo Transmitter provides a choice of 100 selectable frequencies and is equipped with two XLR and 1/4-inch combo input connectors into which users can connect line-level inputs. While up to 10 complete M2 systems may be used on stage simultaneously, any number of M2R stereo receivers may be used on the same frequency with a single M2T stereo transmitter. These rugged systems are built to stand up to the inevitable bumps of life on the road, delivering clear, natural sound for touring and installed-sound uses.
Audio Technica M2 Features
- High-fidelity sound with clean, articulate mix allows you to hear yourself better at lower volume
- 100 selectable UHF channels
- Up to 10 simultaneous systems per frequency band
- Three receiver modes: Personal Mix, stereo, and mono
- Personal Mix Control allows volume and mix control of two independent signals at the receiver
- 3.5 mm line-in jack connects to ambient microphone, click track & more
- LED indicators provide easy-to-read level monitoring
- XLR loop output (true pass-through) connects signal to mixing console, additional IEM system or recording device with no signal degradation
- Adjustable squelch eliminates annoying static
- Pilot tone protects against RF interference when the transmitter is turned off
- Limiter (defeatable) helps protect your hearing from sudden peaks
- Portable system is quick to load and set up
- Reduces on-stage audio clutter for better overall mix & less feedback
- Use any number of M2R Stereo Receivers (with Personal Mix Control) on the same frequency
- Audio-Technica earphones with proprietary dynamic drivers offer full frequency response and outstanding isolation
- Personal fit with 3 sizes of rubber eartips plus an ear-conforming foam tip
- Auxiliary input offers connection point for ambient microphone, click track, or other mic- or line-level input.
Audio Technica M2 Specifications
Overall System Specifications
- Operating Frequencies:
- Band L: 575.000 to 608.000 MHz, 100 frequencies
- Band M: 614.000 to 647.000 MHz, 100 frequencies
- Minimum Frequency Step: 25 kHz
- Modulation Mode: FM stereo
- Maximum Deviation: ±40 kHz
- Dynamic Range: 90 dB (typical), A-weighted
- Total Harmonic Distortion: <1% at (1 kHz, ±20 kHz Deviation)
- Operating Range: 100 m (300 feet), typical
- Operating Temperature Range: -5° C (23° F) to +50° C (122° F)
- Frequency Response: 60 Hz to 13 kHz (+/- 3 dB)
- Simultaneous Use: 10 channels per band (maximum recommended)
Receiver Specifications
- Receiving System: Double conversion superheterodyne
- RF Sensitivity: 20 dBuV (at 60 dB S/N ratio, 50 ohms termination)
- Headphone Output Connector: 3.5 mm TRS stereo phone jack
- Headphone Output Power: 65 mW (at 32 ohms)
- Antenna Input: SMA-type, 50 ohms
- Aux Input Connector: 3.5 mm TRS stereo phone jack
- Batteries: 2 x 1.5V AA (not included)
- Battery Life: 8 hours (alkaline)
- Dimensions (W x D x H): 2.76 x 0.98 x 4.33 inches (70 x 25 x 110mm)
- Net Weight: 110 g (3.9 oz), without batteries
- Accessories Included: EP3 earphone; frequency sticker; flexible antenna
Transmitter Specifications
- RF Power Output: 10 mW/30 mW (switchable), 50 ohms, Limited to 10 mW within 863 MHz to 865 MHz
- Spurious Emissions: Following federal and national regulations
- Input Connections: XLRF-type/6.3 mm stereo (1/4-inch) combination connector
- Maximum Input Level:
- XLRF-type/6.3 mm stereo, (1/4-inch) balanced: +26 dBu
- 6.3 mm (1/4-inch) mono, unbalanced: +26 dBu
- Loop Output Connector: XLRM-type connector
- Power Requirement: 12-18V DC, 600 mA
- Antenna: Attached whip
- Dimensions (W x D x H): 8.30 x 5.20 x 1.70 inches (210 x 132 x 44mm)
- Net Weight: 870 g (30.7 oz), without accessories
- Accessories Included: AC adapter; rack mount adapters
Consumer Alert!Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC’s wireless microphone website at www.fcc.gov/cgb/wirelessmicrophones Note:All of the wireless systems that AMS sells comply with the FCC guidelines and regulations .We are presenting this information as a matter of legally required disclosure.
ex VAT
inc VAT
ex VAT
inc VAT
-
|
Minimum Item Quantity 1 is required to purchase.
Item Quantity exceeds the limit 0 . Questions? Feel free to Call or Chat.
|
|
- Overview
- Specs
- Manufacturer Info
- Also Purchased
- Video & Docs
|
|