Tapco By Mackie SW10 Active Subwoofer  10 Inch  Item #: MAC TAPSW10 

TAPCO SW10 Specifications

Acoustic Performance
• Free Field Frequency Response: 34 Hz - 110 Hz (±3 dB)
• Lower Cutoff Frequency: –3 dB @ 34 Hz
• Upper Cutoff Frequency: –3 dB @ 110 Hz
• Maximum SPL @ 1 meter, 7.5 dBu into both
• Balanced Inputs: 103 dB SPL @ 1m

  Transducer

• Low Frequency Driver: 10 in/254 mm woofer with steel frame, dual voice coil, and paper cone

  Amplifiers

• Rated Power: 120 watts rms into a 4 ohm load (60 watts rms x 2)
• Burst Power: 270 watts rms into a 4 ohm load (135 watts rms x 2)
• Slew Rate: > 15 V/µs
• Distortion (THD, SMPTE IMD, DIM 100): < 0.03%
• Signal-to-Noise Ratio: > 110 dB, 20 Hz to 20 kHz, A-weighted, referenced to 60 watts into 4 ohms
• Type: Monolithic IC, Class AB

  Electronic Crossover

• Crossover Type: 24 dB/octave Linkwitz-Riley
• Crossover Frequency: Variable, 55 Hz to 110 Hz
• Input Impedance: 20 kOhms, balanced bridging; 10 kOhms unbalanced

  AC Power Requirements

• US: 120 VAC, 60 Hz
• AC Connector: 2-pin IEC 250 VAC, 16 A male
• Fuse: 115 VAC: T 1.6 A/250 V
• Power Consumption: 80 watts with music, loud mix 20 watts quiescent (idle)

  Physical Dimensions and Weight

• Enclosure: 0.625 in/16 mm thick MDF
• Damping: Adiabatic fiberfill
• Dimensions:
  • Height: 11.8 in/300 mm, 12.3 in/312 mm w/feet
  • Width: 12.0 in/295 mm
  • Depth: 12.4 in/315 mm
• Weight: 28 lb/12.7 kg

   Manual 565 KB