Peavey Classic 50 410 Guitar Combo Amplifier Item #: PEV 00583180 

Peavey Classic 50 410 Specifications

POWER AMPLIFIER SECTION
• Four 6BQ5/EL84’s with 12AX7 driver
• Rated Power & Load: 50 W RMS into 16 or 8 ohms
• Power @ Clipping (Typically): (5% THD, 1 kHz, 120 V AC line) 50 W RMS into 16 or 8 ohms (Bias must be reduced to measure)
• Frequency Response: +0, -2 dB, 50 Hz to 15 kHz, @ 40 W RMS into 16 ohms
• Hum & Noise: No greater than 80 dB below rated power
• Power Consumption: 200 watts, 50/60 Hz, 120 VAC (Domestic)

  PREAMP SECTION

• Two 12AX7’s

  The following specs are measured @ 1 kHz with the controls preset as follows:
  Pre & Post (lead) @ 0
  Reverb Level @ 0
  Bass & Treble EQ @ 12
  Middle EQ @ 0
  Master Volume @ 12
  Presence @ 6
  Nominal level is with Input Gain @ 6.
  Minimum level is with Input Gain @ 12.
  

• Preamp Normal Input:
• Impedance: Very high Z, 470 K ohms
• Lead Channel (Post Gain @ 10):
  • Nominal Input Level: -40 dBV, 10 mV RMS
  • Minimum Input Level: -70 dBV, 0.3 mV RMS
• Normal Channel:
  • Nominal Input Level: -17 dBV, 140 mV RMS
  • Minimum Input Level: -28 dBV, 40 mV RMS
  • Maximum Input Level: 0 dBV, 1.0 V RMS
• Preamp Bright Input:
  • Impedance: Very high Z, 470 K ohms
    +12 dB boost @ 2 kHz
• Equalization (Lead and Normal Channels): Custom bass, middle, and treble passive-type EQ
• Effects Send:
  • Load Impedance: 1 K ohm or greater
  • Nominal Output Level: -6 dBV, 0.5 V RMS
• Effects Return:
  • Impedance: High Z, 2 MOhms
  • Designed Input Level: -6 dBV, 0.5 V RMS (Switching jack provides Effects Send to Effects Return connection when not used.)
• External Footswitch Function:
  • Reverb Defeat (when reverb control is raised)
  • Normal/Lead Channel Select (when Lead activated)

Manual 2.2 MB