Shure SLX UHF Lapel Wireless Microphone System with WL93 Mic
Delivering superior audio quality in an easy-to-use and quickly configurable package, Shure SLX Lapel Wireless System offers Shure's patented Audio Reference Companding technology for more transmission clarity and dynamic range, along with an innovative setup complete with automatic synchronization, Shure SLX supports up to 20 compatible systems, and setup is nearly effortless.
Shure SLX Lapel Wireless System Features
Shure SLX Wireless Receiver Features
- Shure's patented Audio Reference Companding: Delivers crystal-clear audio transmission, far superior to conventional wireless technology
- Auto Frequency Selection: Locates a clear channel instantly
- Auto Transmitter Setup: Infrared link automatically syncs the transmitter and receiver
Shure SLX Bodypack Transmitter Features
- Detachable 1/4 wave antennas
- Backlit LCD
- Rack-mount hardware included
- 1/4 inch and XLR audio outputs
- Frequency and power lockout
- Volume control on rear of unit
- Rugged metal construction
- Works with headworn, lavalier and instrument microphones and cables
- Timed backlit LCD
- Frequency and power lockout
- Two AA batteries (included) provide 8 hours of continuous use
- 300 foot operating range
- Includes WL93 Micro-Lavalier Microphone
The Auto Frequency Selection and Auto Transmitter Setup on the Shure SLX Lapel Wireless System scans the wireless landscape and identifies a clear channel instantly. Then, guided by an infrared link, at the touch of a button the transmitter automatically syncs with the receiver. With over 960 operating frequencies across 24 MHz of UHF bandwidth, you should be able to quickly and easily set up up to 20 systems (area dependent).
These diversity systems feature metal receivers, rack hardware, detachable antennas, a backlit multifunction LCD display, 1/4-inch and XLR outputs, frequency and power lockouts, an In Line power supply, and a rear-panel volume control. The transmitters feature a timed backlit LCD, frequency and power lockouts, 300 ft. (100m) of operating range, and 8-hour operation on two AA batteries. Includes WL93 Micro-Lavalier Microphone, Shure SLX1 Bodypack Transmitter and Shure SLX4 Diversity Receiver.
Audio Reference Companding
|Shure's patented Audio Reference Companding is currently featured in Shure SLX and ULX Wireless Systems, and in some PSM 700 Personal Monitor Systems (H3 and L2 bands).
Audio Reference Companding: The Basics
What does it do?
Improves wireless sound quality.
What is it?
A more efficient companding scheme.
What is companding?
Companding is the process of compressing the audio signal prior to transmission and expanding it after reception. All pro audio wireless needs companding to deliver a wide dynamic range (greater than 100dB).
How does it work?
Audio Reference Companding is a level-dependent companding scheme. Instead of companding across the entire dynamic range like most wireless systems (causing a whooshing audio artifact known as "breathing"), companding only occurs at high audio levels. These levels are high enough to make the companding artifacts inaudible.
Why is it better?
Sounds more like a wired microphone, with less noise and greater dynamic range than other wireless systems. No artifacts, lower noise floor, clearer sound at all audio levels.
Audio Reference Companding: Tangible Results
Specific attributes of Audio Reference Companding that the listener will notice are:
- No breathing noise
- Lower noise floor
- More headroom - won't clip as easily
- Clearer sound at all audio levels
- Sounds more like a wired mic, as clearly demonstrated by published impulse response curves.
- Operating Range Under Typical Conditions: 100m (300 ft.)
Note: actual range depends on RF signal absorption, reflection, and interference
- Audio Frequency Response (+/– 2 dB):
- Minimum: 45 Hz
- Maximum: 15 kHz
- Total Harmonic Distortion (ref. +/– 38 kHz deviation, 1 kHz tone): 0.5%, typical
- Signal-to-Noise Ratio: >100 dB A-weighted
- Operating Temperature Range: –18°C (0°F) to +50°C (+122°F)
Note: battery characteristics may limit this range
- Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output.
SLX1 Bodypack Transmitter
- Audio Input Level: +10 dBV maximum at 0 dB gain position
- Dimensions: 4.25 x 2.50 x
0.75 in. (108 mm H x 64 mm W x 19 mm D)
- Weight: 3 oz. (81 grams) without batteries
- Housing: Molded ABS case
- Power: 2 “AA” size alkaline or rechargeable batteries
- Battery Life: >8 hours (alkaline)
- Dimensions: 1.65 x 7.76 x
5.28 inches (42 mm H x 197 mm W x 134 mm D)
- Weight: 1 lb. 13 oz. (816 g)
- Housing: Galvanized steel
- Audio Output Level (ref. +/– 38 kHz deviation with 1 kHz
- XLR connector (into 600 ohm load): –13 dBV
- 1/4 inch connector (into 3000 ohm load): –2 dBV
- Output Impedance:
- XLR connector: 200 ohms
- 1/4 inch connector: 1kohm
- XLR output: Impedance balanced
Pin 1: Ground
Pin 2: (+)
Pin 3: (-)
- Sensitivity: –105 dBm for 12 dB SINAD, typical
- Image Rejection: >70 dB, typical
- Power: 12-18 Vdc at 150 mA, supplied by external power supply
Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC’s wireless microphone website at www.fcc.gov/cgb/wirelessmicrophonesNote:
All of the wireless systems that AMS sells comply with the FCC guidelines and regulations.
We are presenting this information as a matter of legally required disclosure.