Studio Projects CS5 Condenser Microphone    Item #: STU CS5 

The Studio Projects CS5 Condenser Microphone is well equiped to handle any recording application. The CS5 is an externally polarized five pattern pressure gradient transducer microphone with FET impedance converter. The CS5 features a 1.06 inch capsule, with a diaphragm thinkness of 6 microns. It features five selectable polar patterns, four selectable pads, four high pass filters, and four low pass filters for added control in various recording applications and a clear, full response expected from a large capsule microphone design.

Versatility is key in the recording arena, and the Studio Projects CS5 is well equiped to handle any recording application. It is designed to deliver the finest quality vocal and instrumental recordings and will serve to enhance any professional or project studio.

Studio Projects CS5 Features

• Pressure-Gradient Transducer: 1.06-inch, 6-micron mylar diaphragm
• FET impedance converter
• Five Polar Patterns: Cardioid, Wide Cardioid, Hyper Cardioid, Omni, Fig 8
• -5dB, -10dB, -15dB, and -20dB Pads
• 50hZ, 75hZ, 150Hz, and 300hZ High Pass Filters at 6dB per octave
• 15kHz, 7kHz, 5kHz, and 3kHz, Low Pass Filters at 6dB per octave

Applications

• Close miking of instruments with high sound pressure levels
• Announcer’s mic for broadcasting and dubbing
• Home recording and project studios
• Vocalist recording
• Spot mic for: wind instruments, strings, percussion and guitar amps
• XY - Coincident Cardioids
• Mid-Side Method
• Stereosonic Technique (Blumlein)
• Overheads

Studio Projects CS5 Specifications

• Type: Pressure gradient transducer microphone
• Polar patterns: Cardioid, Wide Cardioid, Hyper Cardioid, Omni, and Figure of 8
• Frequency response: 20~20000Hz
• Sensitivity: 14mV/Pa=-32dB(0dB=1V/Pa)
• Output impedance: 200 Ohm
• Load impedance: 1000 Ohm
• Maximum SPL: 136 dB SPL for 1% THD @1000Hz (0dB SPL=0.00002Pa) 156dB with -20dB preattnuation
• Equivalent Noise Level: 13dB-A
• S/N: 81 dB-A
• Power requirement: 48 +/- 4V.
• Current consumption: 4mA
• Circuit: JFET impedance converter, discrete balanced output.
• Connector: Gold-plated 3-pin XLR
• Size: dia: 2 inches(52mm) length: 8.5 inches(215mm)
• Pads: -5dB, -10dB, -15dB, and -20dB selectable
• High Pass Filters: 50hZ, 75hZ, 150Hz, and 300hZ 6dB/Octave
• Low Pass Filters: 15kHz, 7kHz, 5kHz, and 3kHz 6dB/Octave

Included Accessories

• Shockmount
• Foam wind screen
• Case

   Frequency Response Chart 217.50 KB