Designed to be the finest sounding digital reverb pedal made today, the Good Verbrations will meet your expectations. The Good Verbrations uses the same proven digital technology found in the highly regarded Verbrator pedal. You’ll find the reverb to be smooth and warm, and the least digital sounding reverb pedal on the market.
Unlike many other reverb pedals, Good Verbrations allows you to adjust both the level and decay of the reverb signal. You can adjust from a tight short decay, to a long and lush decay, and with total musicality. The reverb circuit is an audiophile grade 16-Khz bandwidth digital circuit. Good Verbrations is extremely low noise, simple to operate, and it can run on guitar or -20-db loop level operation. Like all Plush pedals, Good Verbrations can run on a 9-V battery or a DC adaptor, features an ultra-bright bright LED, and features solid cast aluminum power coated enclosure, heat cured silk screening, dual-sided heavy circuit board, premium switches and controls, and premium electronic parts throughout.
The Good Verbrations may be plugged in series with the guitar and amp input, assuming the amp remains clean, and is not a high gain nor overdriven amp. In cases where the amplifier is a channel switching amp, or is high gain, inserting the pedal into the effects loop (post overdrive and pre power amp) will provide a better reverb tone. When using the pedal via an effects loop, take care to insure the signal level is not overloading the input of the pedal, and the output level is set for unity gain (the same level as using the amp without the pedal in circuit). This will give the cleanest, lowest noise tone.
There are two knobs on the Good Verbrations: The decay control adjusts the size and shape of the reverb chamber and decay. The lowest settings are for a small room, mid settings are like a guitar reverb pan, and the higher settings range up to a cathedral tone. The reverb knob adjusts the mix level of wet reverb into the dry signal.
Powering Good Verbrations: The tube FX loop runs on 9VDC, through an alkaline 9V battery (supplied). A 9V adaptor may be used. Fuchs suggests the Visual Sound One Spot or the Godlyke Power Adaptor, both of which are universal adaptors for worldwide use. The pedal is intended to operate on 9-VDC only. If you wish to power your Good Verbrations from an external power supply, it must be capable of furnishing f clean, ripple free 9-VDC, and nothing higher.
CALIFORNIA PROPOSITION 65 WARNING
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.