Fender 008099600 4 Button Footswitch for Mustang III - IV - V
The Fender 008099600 4 button footswitch for Mustang III, IV, V enables remote multi-function foot control. The footswitch display and LEDs show you some of the same information as the amplifier screen, so you can tune your guitar and select presets by watching the footswitch without ever looking at the screen onboard the Mustang! By assigning different functions to each footswitch you can create more than a dozen different foot control combinations!
Fender 008099600 4 Button Footswitch for Mustang III, IV, V Features:
- Works with Mustang Guitar Amplifer models III, IV, and V
- LED to indicate 3 Modes
- Tuner Mode
- Select Quick Access presets (QA1/QA2/QA3) Button
- Select presets (up/down/bank) Button
- Bypass effects Button
- Activate the Tuner Button
The Fender footswitch has three modes that are identified by the three LEDs labeled MODE 1, MODE 2 and MODE 3. The footswitch also has a Tuner mode which is indicated when all of the mode LEDs are off. To switch between modes, press the MODE button. To activate Tuner mode, press and hold the MODE button.
Press and hold the MODE button to activate the Tuner. The screen and the footswitch both will display the same tuner information so that you can look in either place to tune your guitar. The footswitch will display the nearest note; the button LEDs will indicate sharp and flat and "in tune" is indicated when the green LED below the footswitch display lights up. Press any footswitch button to exit Tuner mode.
In Mode 1 the footswitch is used to select one of three Quick Access presets, using the buttons labeled: QA1 /QA2 / QA3 (in line with the MODE 1 LED). When you select a Quick Access preset, the number of the preset will appear in the display of the footswitch. You can assign any preset to be a Quick Access preset in the Utility menus.
In Mode 2 the footswitch is used to select presets down/up, or in banks of 10, using the buttons labeled: DOWN/ UP / BANK (in line with the MODE 2 LED). When you select a preset, the number of the preset will appear in the display of the footswitch.
In Mode 3 the footswitch is used to bypass the Stompbox, Modulation or Delay effects, using the buttons labeled: STOMP / MOD / DELAY (in line with the MODE 3 LED). The footswitch button LEDs indicate the effects that are active, just like the buttons on the amplifier.